Planet FGSW-1816HPS Ethernet Switch

SPECIFICATIONS:
Hardware Specifications:
• 10/100Mbps Copper Ports: 16 10/100Base-TX RJ-45 Auto-MDI/MDI-X ports
• Gigabit Copper Ports: 2 10/100/1000Base-T RJ-45 Auto-MDI/MDI-X ports
• SFP/mini-GBIC Slots: 2 1000Base-X SFP interfaces, shared with Port-17 to Port-18
• Switch Architecture: Store-and-Forward
• Switch Fabric: 7.2Gbps / non-blocking
• Throughput: 5.35Mpps@64Bytes
• Address Table: 4K entries, automatic source address learning and ageing
• Share Data Buffer: 2.75Mb embedded memory for packet buffers
• Flow Control: IEEE 802.3x pause frame for full-duplex, Back pressure for half-duplex
• Maximum Transmit Unit size (MTU size): 1536 Bytes
• Reset Button:
- < 5 sec: System reboot
- > 5 sec: Factory Default
• Dimensions (W x D x H): 440 x 200 x 44.5 mm, 1U height
• Weight: 2.55kg
• LED:
- System: Power (Green)
- 10/100Base-TX RJ45 Interfaces (Port1 to Port16): 10/100Mbps LNK/ACT (Green), PoE In-Use (Orange)
- 10/100/1000Base-T RJ45 / SFP Interfaces (Port17 to Port18): LNK/ACT (Green), 100/1000 (Green)
- PoE Usage; 50W, 100W, 150W, 190W (Orange)
• Cable Twisted-Pair:
- 10Base-T: 2-Pair UTP CAT. 3, 4, 5, up to 100 meters
- 100Base-TX: 2-Pair UTP CAT. 5, 5e up to 100 meters
- 1000Base-T: 4-Pair UTP CAT. 5e, 6 up to 100 meters
• Cable Fiber-Optic Cable:
- 1000Base-SX: 50/125μm or 62.5/125μm multi-mode fiber optic cable, up to 550m (varying on SFP module)
- 1000Base-LX: 9/125μm single-mode fiber optic cable, up to 10/20/30/40/50/70/120 kilometers (varying on SFP module)
• Power Requirements: 100~240V AC, 50/60Hz, 4A
• Power Consumption: Max. 240 watts / 816 BTU
• ESD Protection: 2KV DC

Power over Ethernet:
• PoE Standard: IEEE 802.3af / 802.3at PoE / PSE
• PoE Power Supply Type: End-span
• PoE Power Output: Per Port 52V DC, Max. 30.8 watts
• Power Pin Assignment: 1/2(+), 3/6(-)
• PoE Power Budget: 220 watts (max.)
• PoE Ability PD @ 7 watts: 16 units
• PoE Ability PD @ 15.4 watts: 14 units
• PoE Ability PD @ 30.8 watts: 7 units

Layer 2 Functions:
• Port Configuration: Port disable / enable, Auto-negotiation 10/100/1000Mbps full and half duplex mode selection, Flow Control disable / enable
• Port Status: Display each port’s speed duplex mode, link status, flow control status, auto negotiation status and trunk status
• Port Mirroring: TX / RX / Both, Many-to-1 monitor
• VLAN:
- 802.1Q tagged-based VLAN, up to 32 VLAN groups, out of 4094 VLAN IDs
- Port-based VLAN, up to 18 VLAN groups
- MTU VLAN
• Link Aggregation: 2 groups of 4-Port 10/100Base-TX trunk supported, 1 group of 2-Port 10/100/1000Base-T trunk supported
• QoS:
- Allow to assign low / high priority on each port
- First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy
• IGMP Snooping: IGMP (v1/v2) Snooping, up to 32 multicast groups
• Security Control: MAC address binding, TCP & UDP filter

Management Functions:
• Basic Management Interfaces: Web Browser, SNMP v1

Standards Conformance:
• Regulation Compliance: FCC Part 15 Class A, CE
• Standards Compliance: IEEE 802.3 Ethernet, IEEE 802.3u Fast Ethernet, IEEE 802.3ab Gigabit Ethernet, IEEE 802.3z Gigabit Ethernet, IEEE 802.3x Full-duplex flow control, IEEE 802.1Q VLAN, IEEE 802.1p QoS, IEEE 802.1D Spanning Tree Protocol, IEEE 802.1w Rapid Spanning Tree Protocol, IEEE 802.3af Power over Ethernet, IEEE 802.3at Power over Ethernet Plus

Environment:
• Operating:
- Temperature: 0 ~ 50 degrees C
- Relative Humidity: 5 ~ 95% (non-condensing)
• Storage:
- Temperature: -10 ~ 70 degrees C
- Relative Humidity: 5 ~ 95% (non-condensing)


FEATURES:
Physical Port:
• 16-port 10/100Base-TX RJ-45 copper with PoE in-line supported
• 2-port 10/100/1000Base-T RJ-45 copper
• 2 1000Base-X mini-GBIC/SFP slots to share with Port-17 to Port-18
• Reset button for system management
PoE:
• Complies with IEEE 802.3at High Power over Ethernet End-Span PSE
• Complies with IEEE 802.3af Power over Ethernet End-Span PSE
• Up to 16 IEEE 802.3at / 802.3af devices powered
• Supports PoE Power up to 30.8 watts for each PoE port
• Detects powered device (PD) automatically
• Circuit protection prevents power interference between ports
• Remote power feeding up to 100m
• PoE Management: Per port PoE function enable/disable, PoE Port Power feeding priority, Per PoE port power limit, PD classification detection, PoE Power sequential, PoE schedule
Layer 2 Features:
• Auto-MDI/MDI-X detection on each RJ-45 port
• Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
• Supports broadcast storm control
• Supports VLAN:
- IEEE 802.1Q tag-based VLAN, up to 32 VLANs groups, out of 4095 VLAN IDs
- Port-based VLAN, up to 16 VLAN groups
- MTU VLAN (Multi-tenant Unit VLAN)
• Supports Link Aggregation: 802.3ad Link Aggregation Control Protocol (LACP), Cisco ether-channel (Static Trunk)
• Supports Spanning Tree Protocol:
- STP, IEEE 802.1d Spanning Tree Protocol
- RSTP, IEEE 802.1w Rapid Spanning Tree Protocol
• Port mirroring to monitor the incoming or outgoing traffic on a particular port
• Provides port mirror (Many-to-1)
• Loopback protection to avoid broadcast loops
Quality of Service:
• 2 priority queues on all switch ports
• Traffic classification: Port-based priority, IEEE 802.1p-based priority, IP TOS / DSCP-based priority, TCP / UDP port-based QoS
• Strict priority and Weighted Round Robin (WRR) CoS policies
Multicast:
• Supports IGMP Snooping v1 and v2
Security:
• Physical port to MAC address binding
• TCP/UDP port number filter: Forwarding or discarding typical network applications
• Port mirroring to monitor the incoming or outgoing traffic on a particular port
Management:
• Switch Management Interfaces: Web switch management, SNMP v1 switch management
• Supports DHCP Option82 and DHCP Relay
• Firmware upload/download via HTTP
• Hardware reset button for system reboot or reset to factory default

PoE IP Surveillance with Extended Network Infrastructure for SMBs / Workgroups
Providing 16 10/100Base-TX PoE ports, in-line power interfaces and two gigabit TP/SFP Combo interfaces, the FGSW-1816HPS can easily build a power centrally controlled IP camera system for the enterprises. It can work with one 16-channel NVR to perform comprehensive security monitoring with 16 IP cameras via one gigabit TP/SFP Combo port. The FGSW-1816HPS comes with non-blocking design, desktop size and SFP fiber-optic modules, bringing network infrastructure to higher flexibility but lower in cost.

Rapid Spanning Tree Protocol for Efficient Network System
The FGSW-1816HPS features strong rapid self-recovery capability to prevent interruptions and external intrusions. It incorporates Rapid Spanning Tree Protocol (802.1w RSTP) into customer’s automation network to enhance system reliability and uptime.

Ideal Solution for Secure IP Surveillance Infrastructure
Particularly designed for the growing popular IP surveillance applications, PLANET FGSW-1816HPS 802.3at PoE web smart switch is positioned as a surveillance switch with the central management of remote power control and IP camera monitoring. The FGSW-1816HPS provides intelligent PoE functions along with 16 10/100Base-TX ports featuring 30-watt 802.3at PoE+ with RJ-45 copper interfaces and 2 Gigabit TP/SFP combo interfaces supporting high-speed transmission of surveillance images and videos.

Perfectly- integrated Solution for PoE IP Camera and NVR System
Being different from the general IT industrial PoE switch which usually contains 12 or 24 PoE ports, the FGSW-1816HPS provides 16 802.3at PoE+ ports for catering to medium to large scale of IP surveillance networks at a lower total cost. With its 7.2Gbps high-performance switch architecture and 220-watt PoE power budget, the recorded video files from 16 PoE IP cameras can be powered by the FGSW-1816HPS and saved in the 8 / 16 / 32-channel NVR systems or surveillance software to perform comprehensive security monitoring. For instance, one FGSW-1816HPS can be combined with one 16-channel NVR and 16 PoE IP cameras as a kit for the administrators to centrally and efficiently manage the surveillance system in the local LAN and the remote site via Internet.

Intelligent LED Indicator for Real-time PoE Usage
The FGSW-1816HPS helps users to monitor the current status of PoE power usage easily and efficiently by its advanced LED indication. Called "PoE Power Usage", the front panel of the FGSW-1816HPS Fast Ethernet PoE+ Switch has four orange LEDs indicating 50W, 100W, 150W and 190W of PoE power usage.

PoE Schedule for Energy Saving
Besides being used as an IP Surveillance, the FGSW-1816HPS is certainly applicable to constructing any PoE network including VoIP and wireless LAN. Under the trend of energy saving worldwide and contributing to environmental protection on the Earth, the FGSW-1816HPS can effectively control the power supply besides its capability of giving high watts power. The "PoE schedule" function is for you to enable or disable PoE power feeding for each PoE port during specified time intervals and it is a powerful function to help SMBs or enterprises save power and money.

Robust Layer 2 Features
The FGSW-1816HPS can be programmed for advanced switch management functions such as dynamic port link aggregation (LACP), Spanning Tree Protocol (STP), IGMP Snooping v1, v2, bandwidth control and L2/L4 security control. The FGSW-1816HPS provides IEEE 802.1Q tagged VLAN, port-based VLAN and MTU VLAN. The VLAN groups allowed will be maximally up to 32. Via aggregation of supporting ports, the FGSW-1816HPS allows the operation of a high-speed trunk combining multiple ports and supports fail-over as well.

Flexible and Extendable Uplink Solution
The FGSW-1816HPS provides 2 extra Gigabit TP/SFP combo interfaces supporting 10/100/1000Base-T RJ-45 copper to connect with surveillance network devices such as NVR, Video Streaming Server or NAS to facilitate surveillance management. Or through these dual-speed fiber SFP slots, it can also connect with the 1000Base-SX/LX SFP (Small Form-factor Pluggable) fiber transceiver to uplink to backbone switch and monitoring center in long distance. The distance can be extended from 550m to 2km (multi-mode fiber), even going up to above 10/20/30/40/50/70/120km (single-mode fiber or WDM fiber). They are well suited for applications within the enterprise data centers and distributions.